null

Static Cone Penetrometers

Static Cone Penetrometers

A static cone penetrometer measures soil cone resistance with a steady push instead of a hammer. Its dual-rod design keeps shaft friction out of the reading, and a hydraulic gauge reads cone stress directly from 0 to 70 kg/cm². Use this cone penetrometer to check the consistency, compaction and bearing capacity of fine-grained, soft soils under foundations and pavement subgrades. Shop complete penetrometers, starter and extension rods, and 1.5cm² or 3cm² cones. To test with a drop hammer, see dynamic cone penetrometers or browse all soil penetrometers.

ACCURATE
RELIABLE Testing You Can Trust
ASTM
QUALITY Trusted Brands
WIDE RANGE
WIDE RANGE Testing Equipment & Supplies
Static Cone Penetrometers

How a Static Cone Penetrometer Works

A static cone penetrometer has two rods. The inner rod carries the cone and moves on its own, so soil friction along the outer rod does not affect the reading. The load on the cone travels up the inner rod to a hydraulic load cell, and the gauge shows cone stress directly.

Running the Test

Press the penetrometer 6in (152mm) into the soil at a steady rate and take a reading. Advance another 6in and take the next reading. Repeat until the starter rod is buried, then add 2ft extension rods to go deeper.

Choosing a Cone

The 1.5cm² cone is the standard cone and comes with most penetrometers. The 3cm² cone is for very soft soils, and you halve the gauge reading when you use it.

Getting the Best Results

Fine-grained, soft soils give the most accurate readings. Gravel and rock can cause misleading readings, so in those soils use a dynamic cone penetrometer.

For quick strength checks at the surface, compare pocket penetrometers. To sample the same soils, see our Shelby tubes.

[]