Atomizing Spray Head for Moisture Room Control Panel

Atomizing Spray Head for Moisture Room Control Panel

Atomizing Spray Head is a component of the Moisture Room Control Panel system and is installed on water lines to distribute moisture throughout the concrete curing room. The number of spray heads required is based on room dimensions. Approximate flow rate is 1.5gph (5.7lph), dependent upon water pressure. 

Moisture Room Control Panel is a wall-mounted system that automatically blends hot and cold water supplies to keep your concrete specimen curing environment at precisely 73.4 ± 3°F (23 ± 1.7°C) and 100% humidity. It is a stand-alone device used specifically with Atomizing Spray Heads and does not integrate with other foggers, misting devices, compressed air, or HVAC units. A dedicated hot water tank is recommended to assure constant temperatures.

The easy-to-read digital controller display allows simple input of temperature set points for automated control. A manual bypass system assures continuous maintenance of specified temperature and humidity levels if power is interrupted. The panel has space to add a temperature recorder or data logger, available separately. Quick-connect water line fittings are fast and easy to install. Inquire for custom design of a closed-loop layout with atomizing spray head pattern for your cure room based on room dimensions, and water temperatures and pressures. One-pass water chillers also available as required.

Typical Moisture Room Setup Diagram

Length 2in (51mm)

Material          Brass